| INTRODUCTION
The Universal Charge Bar™ models are highly
accurate, easily adjustable powder and shot measuring instruments.
- Model
"C/CS" replaces all the standard charge bars and bushings
used in MEC single-stage reloading machines (MEC600Jr., 700Versamec,
Sizemaster 77, MEC600, 400, 250 and 250 Super, Mark 5, and Texan
LT, GT, and FW). (See picture)
-
Model "D/DS" replaces all the standard charge bars
and bushings used in MEC progressive reloading machines (MEC650,
MEC Grabber, MEC9000, et cetera). (See below drawing)
- Fig
1: Model "D/DS" Drawing
For Model "C/CS", the powder cavity and powder valve
are at the right end of the bar and the shot cavity and shot
valve are at the left end of the bar.
-
Model " Shuttle Bar " replaces all the standard charge
bars (for Shot only,
not for Powder) used in MEC single-stage reloading machines
(MEC600Jr., 700Versamec, Size master 77, MEC600, 400, 250 and
250 Super, Mark 5, and Texan LT, GT, and FW). The Shuttle Bar
must only be used together with MEC Powder Bushing and MEC Powder
Chart(See picture)"
-
Powder Baffle used to install between powder-bottle and Charge
Bar to produce even powder density, and therefore consistent
charges. (See picture)
FEATURES
Model "C/CS" and model "D/DS" Features:
- Can
be used for reloading Lead-shot, Steel-shot, Bismuth and Powder
- Can
be used for all gauges, for both field and target loads
-
Fully adjustable from 1/2 oz. to 2 1/4 oz. for lead shot,
from 7/8 to 1 1/2 oz/ for steel shot, and
from 12 grs to 55 grs for powder
-
Model “Shuttle Charge Bar” has the same features
as "C/CS" and "D/DS" model, except the powder
side must be used with the Standard Powder Bushings.
_____________________________________________________________________
|
