|
Picture and Line Drawing
Models "D/DS" (upper)
and "C/CS" (lower)
Model "D/DS" (upper bar, above) has the shot cavity
on the right.
Model "C/CS" (lower bar, above) has
the shot cavity on the left
_____________________________________________________________________
Model "C/CS" with
shot cavity inserts in foreground
'Mushroom shaped' inserts are provided for the
shot cavity.
Replacement inserts can be ordered when needed.
_____________________________________________________________________
Model "C/CS", powder
baffle, and Model "D/DS"
(retail packaging)
When you are thinking about a present
for your friends and relatives, consider the above products.
They will appreciate you for the convenience of our reloading
products as well as for the additional money that our products
will save them.
_____________________________________________________________________
Powder Baffle
The simple to use, inexpensive POWDER
BAFFLE is designed to help the powder flow more evenly
and, at the same time, to provide a powder seal between the
bar and the machine.
_____________________________________________________________________
Powder Baffle
The above diagram shows how the POWDER
BAFFLE is contructed.
_____________________________________________________________________
Powder Baffle
Here we have two MEC machines with our powder
baffles attached to them; the MEC in the background has an original
charge bar while the MEC in the foreground is using the Universal
Charge Bar™
Below we have just one MEC machine with the
powder bottle attached to the powder baffle; the MEC is shown
here using the Universal Charge Bar™
_____________________________________________________________________
Scales
The scale shown on end of the Universal Charge
Bar™ body has a ratio of 40:1 with the scale seen on the
adjustment knob. (The relationship between the bar scale and
the knob scale is explained in more detail elsewhere).
_____________________________________________________________________
Model "D/DS" Drawing
One difference between models "D/DS"
and "C/CS" is that additional mounting
parts are included with the model "D/DS"
because the model "D/DS" is designed
to be used with the Progressive MEC reloading machines.
Parts for the "D/DS"
Model are marked with and asterisk (*) in the above diagram
_____________________________________________________________________
Model "D/DS" Drawing
For Model "C/CS",
the powder cavity and powder valve are at the right end of the
bar and the shot cavity and shot valve are at the left end of
the bar.
_____________________________________________________________________
Read ALL instructions carefully before beginning.
_____________________________________________________________________ |
